INTEGRAL BLADE STABILIZERS
FEATURES: "UDT Make" integral blade stabilizer has a single body made of 4145 H modified alloy steel fully heat-treated to 285-341 Brinell hardness and 40 ft lb minimum impact strength. UNITED stabilizers are available in either near bit or string type. Connections are cold-rolled, phosphatized, coated and equipped with thread protectors. These are gauged to API standards. SPECIAL FEATURES: Deep spiral machining to allow maximum mud circulation. Long  fishing neck and bottom neck. Wide blades and long wall contact to increase wear resistance and wall contact.
DIMENSIONAL DATA – INTEGRAL BLADE STABILIZER

Hole Size Range (In)	DC Diameter Range (In)	Blade Length (In)	Blade Width (In)	Fishing Neck Length (In)
6 1/8 - 6 3/4	4 1/8 - 4.3/4	10	2	20
73/8 - 7.7/8	53/4 – 61/4	10	2.3/8	24
8.1/2 - 8.3/4	61/4 - 7	15	2.3/8	24
9.1/2.9718	7 - 8	15	2.3/8	26
10.5/8-11	7 -  8	15	3.1/8	26
12-12 1/4	73/4 - 91/2	16	4	26
143/4 - 15	8 - 10	16	4	26
173/8 - 171/2	8 - 10	21	5	26
22 - .23	9 - 11	21	5	30
24 - 26	9 - 11	24	5	30

 

Licence No.API 5CT-0565
Licence No.API 5L-0424
Licnece No.API 11V1-0014
Licence No. API-7-0393
Licence No.API-7-1-0393

Home | About Us | Wireline Winch Units | Gas Lift Equipments | Down Hole Tools | Handling Tools
Quality Certificates | References | Enquiry | Site Map